IBMO OS/2 Driver

The OS/2 driver enhances the Graphical User Interface (GUI) of IBM operating
systems. The OS/2 driver only works with IBM OS/2 versions 2.11, 3.0, and
4.0.

OS/2 Installation
Follow the procedure listed below to install the OS/2 display driver. If you
are installing OS/2 for the first time, install OS/2 for VGA first and
reconfigure the driver later.

1.	Open an OS/2 Window.
2.      Place the driver cdrom into cdrom Drive d: and
        click OK.
3.	At the command prompt type

                SETUP d: C:

where 'd' signifies your source drive and 'C' signifies your OS/2 boot drive,
then press [Enter]. Read the message and press [Enter] again.

4.	From the Display Driver Install dialogue box, check Primary Display
        and click OK.
5.	Select the GD546X driver from the list of drivers.
6.	Next, verify the correct Source Directory and click Install to begin
        the installation process.
7.	From the Display Driver Install information box, click OK to proceed.
8.	The Setup Program will take you back to the OS/2 Window once the
        driver has been copied to your bootable drive. Type

		Exit
        at the prompt and press [Enter].

10.	Shutdown to restart OS/2 with your newly installed  OS/2 driver.

Configuring the OS/2 Driver
To configure your OS/2 driver once it is installed, follow the procedure
listed below.

1.	Click on the System icon in the System Setup folder.
2.	Select the Screen tab to display resolutions and screen refresh
        rates on page one of the System Settings dialog box.
3.	Select the resolution and refresh rate you want and click on the OK
        button.
4.	Shutdown and restart your system for the changes to take effect.


