
Package README - REALmagic RMPRO MPEG Device Driver

This readme file contains information on how to install the REALmagic RMPRO MPEG
device driver.   This OS/2 driver supports MPEG motion video playback.

README.1ST CONTENTS:

1.0 SYSTEM REQUIREMENTS
2.0 PRELIMINARY STEPS
3.0 INSTALLATION
4.0 PROBLEM DETERMINATION & TECHNICAL SUPPORT
5.0 REALmagic RMPRO MPEG Device Driver CONTENTS.
6.0 TRADEMARKS

1.0 System Requirements

Before you install the REALmagic RMPRO MPEG device driver, make sure that you have:
        a) installed OS/2 WARP Version 4.0
        b) 12 MB of system memory
        c) 2 MB of hard disk space

2.0 PRELIMINARY STEPS

    a) Back up orginal CONFIG.SYS and MMPM2.INI file from your system in case
       problem occurs.

3.0 INSTALLATION

    1) Unzip the VIDRMP.ZIP into any directory.
    2) Type 'MINSTALL' to install the driver.
    3) Follow panel instructions to complete installation.
    4) After installation is completed, shutdown the system and reboot.
       Note: The installation adds the following statements to your config.sys file.
       For example:
          DEVICE=D:\MMOS2\VIDRMP.SYS /IO:0260 /IRQ10 /1
          DEVICE=D:\MMOS2\RMAUDIO.SYS T:REEL_MAGIC P:0260 I:10 N:RMAUD1$
               where D is any drive
    5) Please read the RMREAD.TXT under MMOS2\HELP directory to set up the
       RealMagic Pro driver before you can use it.

4.0 Problem Determination & Technical Support

    No known limitations for this driver.

5.0 REALmagic RMPRO MPEG Device Driver Package contents:

This package contains the following files:


    CARDINFO.DLL
    CBARS.VBS
    CONTROL.SCR
    DSPPIC2.BIN
    R0STUB.SYS
    RMAUDIO.SYS
    RMPMRI.DLL
    RMPPAGE.DLL
    RMREAD.TXT
    SETUP.SCR
    SMVSH.HLP
    VIDFILES.SCR
    VIDHELP.HLP
    VIDRMP.SYS
    VIDRMP1.INI
    VREEL.BIN



6.0  TRADEMARKS

The following terms, denoted by an asterisk (*) in this file, are trademarks or registered
trademarks of IBM Corporation in the United States and/or other countries:

IBM
OS/2

